Empire: Bank Raid

[Duke2004]

here you go.13122011493.jpg13122011494.jpg13122011495.jpg13122011496.jpg13122011499.jpg

[Johnny's Amusements]

From what I can see your coin mech. is plugged in correctly. On the shelf where all the tubes are there is a plug underneath. Take out the shelf by removing the bolt holding it in & make sure all the plugs are connected. IF you can remove the coin tube shelf & take a couple of close up pictures I will look for any faults. What happens when you put a £1 coin in? It should accept it and put it into the PURPLE payout tube, the one at the back. Also try putting the machine into test by pressing the black test switch on the right hand side. Go into coin payout test & press the hold buttons. This should make the coin payslides pulse & payout coins if there are any in the tubes. This perticular machine needs 20p coins in the YELLOW tube & pound coins in the purple tube. Let me know how you get on.

[Duke2004]

ok i tuck out all the tubes and found out that everytime i put a £1 in it falls to the bowl where you win. nothing go's to the tubes. i checked all the connections behind the tubes and they are all connected. I could not find the Test button on the right, sorry. heres some pictures and what i did get.13122011508.jpg13122011511.jpg

[Johnny's Amusements]

You did not need to take out the tubes individually! That whole shelf with the payslides & tubes just slides out in one piece. Put all those tubes you have removed back in again! What is wrong as far as I can see is looking at picture no.2 the whole payout unit is not connected. The big red & white plug at the right hand side of the pic needs to be plugged in. You should be able to see the socket which is at the end of a lead. It will be hanging loose somewhere under the shelf. If you slide the whole shelf out (by removing just one bolt which you can just see in pic 1, next to the red & black level sensor which you have taken off). Please replace all the tubes & sensors onto the tubes secured by black rubber bands. Let me know how it goes & post another pic so I can see that you have re assembled the tubes correctly.

[Duke2004]

i tuck pictures befor i started removing all the tubes. everythings back as it was. all the connections are back connected. i cant find the test switch you spoke about befor. the money that i put in falls to the winnings draw. its like it dose not register that the money is going in. i read somewhere that there is ment to be a light on the validator when you switch the machine on but there dose not seem to be any place for a light to come on. if i could find that test switch i mite be able to find out if the validator is working.